Race Track Play Mat

I have some pretty great neighbors. Sadly they are moving away this week, and by away I mean far far away, out of state away, away all the way to California away…sniff, sniff! You may remember the dad’s appearance on my blog from some time ago here, and the mama recently abducted a finished project I was planning to blog. At any rate, their  youngest just turned 2, and I wanted to do a little something to celebrate his birthday and came up with this simple race track play mat – a rectangle mat with a race track on the inside, and a set of handles along with a pocket on the outside to hold a few cars.


Race Track Mat Tutorial

Materials

  • Fabric – main and contrast (I purchased 1/2 yd of each)
  • Scrap of fusible interface for snap backing
  • Metal snap (or other closure system)
  • Felt (I used two pieces of the pre-cut rectangles)
  • Coordinating thread
  • Supplies for the handles (I used webbing, or you could sew one with the remaining fabric)

Steps

Cut pieces for the bag:

  • Body: 2 rectangles, one from the main and one from the contrast fabric (mine were 18 x 13 1/2).
  • Pocket: 2 smaller rectangles for the pocket body – needs to fit onto one side of the main body when folded in the carrying mode (mine was 9 1/2 x 6 1/2).
  • Pocket flap – 2 small pieces for the flap. (mine was 9 1/2 x 3 1/2)

Cut felt to make race track. I folded the felt in half length wise, cut one the top half of the figure 8, and then traced it to make the bottom half on the second piece of felt.

Once cut, I pinned the pieces to the contrast fabric for the inside of the play mat and stitched it in place. I stitched around both the outside and inside of the track, and also ran a zigzag down the center where the two pieces meet to secure those edges. With the track firmly in place, I moved to the outside of the bag, creating a car pocket.

Both the pocket body and flap were sewn with the right sides together, leaving a small opening to turn the fabric. Once turned, I pressed the fabric and top-stitched around the top edge on the main body to close the opening. For the pocket flap, top-stitch three of the sides (one long and both short ends).  Determine the placement for the pocket and flap, and then sew each piece to the front of the main fabric of the play mat, stitching down and around the packet body, and across the single long edge of the pocket flap.

In preparation for the final assembly, I attached the fusible interfacing to the backside of the contrast fabric, and ran a little basting stitch to hold webbing handles to the main body of the mat – remember to have all the raw edges lined up.

With the right sides facing together, I sewed around the edges of the bag leaving a small opening for turning. Clip the corners and turn right side out.

Instal the closure per manufacturer’s instructions, leaving enough space for top stitching. Run a top stitch around the edge of the mat to close the opening and create a nice finished look…

…and then, go make a little person happy.

Advertisements

4 thoughts on “Race Track Play Mat

  1. even I might be able to follow those directions . thank you so much . mine will g o in my operation c Christmas child boxes with some chunky wood trucks I found

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s